Install a Dash Kit with Factory Screen Retention in Dodge Journey

Quick answer

Install the Metra 99-6520B dash kit to replace your Dodge Journey's radio while keeping the factory 4.3-inch screen. The matte black finish matches the original trim, and the process takes about an hour with basic hand tools.

Step-by-Step Installation Guide

1. Disconnect the battery and remove the factory radio: Disconnect the negative battery terminal. Use a trim removal tool to pry off the radio bezel, then remove the four Phillips screws holding the factory radio. Slide the radio out, unplug the wiring harness and antenna, and set the radio aside. Label the harness connectors with masking tape to avoid confusion during reconnection.
2. Install the Metra 99-6520B mounting bracket: Align the Metra 99-6520B bracket over the factory radio opening. Secure it using the supplied screws—do not overtighten, as the plastic can crack. Ensure the bracket sits flush against the dashboard. Check that the bracket does not block the factory screen's view or touchscreen operation.
3. Mount the aftermarket radio into the dash kit sleeve: If your radio uses a metal sleeve, slide it into the Metra 99-6520B adapter ring. For radios with a threaded front, use the included screws to attach the adapter ring directly. Tighten evenly to avoid warping the sleeve. Use the screws that came with the dash kit—not the radio's screws—to ensure proper fit.
4. Slide the radio assembly into the bracket and secure it: Push the radio and sleeve assembly into the mounting bracket until it clicks or snaps into place. If your kit uses screws, install them through the side tabs. Reconnect the wiring harness and antenna before fully seating the radio. Make sure the factory screen cable is not pinched between the bracket and the radio assembly.
5. Reattach the factory screen and test operation: Snap the factory 4.3-inch screen back into its original position. Reconnect the battery, turn the ignition to accessory mode, and test the radio and screen functions. Verify that the screen displays correctly and the radio powers on without errors. If the screen does not light up, check the ribbon cable connection at both ends and reseat it firmly.
6. Snap the trim bezel into place: Align the Metra 99-6520B trim bezel over the radio and screen assembly. Press firmly around the edges until it clicks into the bracket. The bezel should be flush with the dashboard with no gaps. If the bezel feels loose, remove it and check that all mounting tabs are fully engaged before pressing again.

Product Facts

• Metra 99-6520B 2011-up Dodge Journey Dash Kit with Factory 4.3" Screen Retention: Designed for 2011-up Dodge Journey; retains factory 4.3-inch screen; matte black finish. You can upgrade the radio without losing the factory display, and the color matches your dashboard perfectly.